Doxie Go Original Series has been discontinued since 2017 and is now obsolete. Limited support is available on this help site. Click here for more information. Have a Doxie Go SE or another newer Doxie model? Click here for current Doxie product support.

Set Up Doxie Go (USB)

These alternative setup instructions are for Doxie Go models that didn't include a power adapter. If your Doxie has a power adapter, follow these setup steps instead.

  1. Charge up your scanner's battery.
    Plug Doxie into any USB port for an initial charge cycle. Leave the scanner off during initial charging. Doxie’s power light turns orange when charging, and turns off when fully charged. It takes a few hours to fully charge the battery, but if you're anxious to get started, you can move to the next step after 30-45 minutes.

  2. Disconnect Doxie from your computer.

  3. Turn on Doxie and calibrate.
    Hold the power button for a moment. When the light stops blinking, Doxie is ready to scan. Insert the included calibration sheet, face up -- Doxie will automatically calibrate.

That's it! Now you're ready to scan.

Next, learn more about scanning...